I will caution that since I bought it a couple of years ago, Loxone does seem to be moving more and more towards closed systems, and are increasingly reticent to support self-installers. Failing that, they have a few videos on Youtube showing how it all works. Loxone does occasional open evenings at a pub near where they're based in Reading. The programming environment for Loxone is extremely powerful and easy to use, which was really what swung it for me. That might have been FUD from Loxone though. It's better than what I've seen of, eg, Control4, and to be honest, I hardly use it because most of what it controls is either automatic (heating/DHW/blinds) or has a hard switch (lights, blinds).Īnyone compared this to z-wave? they seem cheaper on components.įrom memory, Z-wave is cheaper, but there's a much more limited selection of components, and I seem to recall there being issues with range and reliability of the protocol as a whole. The only other question mark I have over them is their interface. They're always more than helpful when you have technical questions. I started looking into doing something more formal about it, but didn't have the time or energy as I was buried in the build at the time.Īll that said, they're a really good company and they're putting together some really great tech. I was basically fobbed off when I raised it with them. That might have been ok if if you could have ordered from the German site, but you couldn't, which as far as I'm concerned is contrary to EU regs. They argued that they wanted to be able to fix prices for a year or two at a time and didn't want to keep reprinting materials with new prices. I also had serious problems with the significantly higher pricing they had in the UK at the time I bought. I don't think they do it on purpose - I think they genuinely expect that most of the people on the course will be trade (as were 90% of the guys on the course I did). I provided what I thought was pretty clear feedback about how misleading this was, and then HerbJ had a similar experience only a few months later. I was led onto the course largely based on this discount, but was then calmly told when I went to claim it a couple of weeks later that the discount was only for trade. It was quite a bit less than that when I did it, I think - less than £200 from memory.Īlso, do check whether the discounts that you're reading about are actually offered to non-trade punters. I'd also recommend joining (or at least reading) a couple of the forums that were set up when the official one was pulled last year. Once I'd done that, I was able to do all the programming myself. I looked at some online training stuff before starting but I found having someone take me through it by the hand really invaluable. It you haven't already done it, I'd highly recommend doing at least the first three days of the Loxone training courses. I m hoping I can shut myself away and get my head around programming it myself. Whilst it is a chunk, its probably saved me a couple of thousand pounds on heating controllers, solar controllers, dimmable light switches, burglar alarms etc. I would say all in its going to cost around £7k on the kit, but that includes 18 speakers, 12 music zones, and a shed load of lighting zones. I ve got all my Loxone kit in the garage and waiting to be installed imminently - basically controlling blinds, lighting, heating, burglar alarm, solar thermal, music, garage door, entrance gates.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |